Analisa Pengaruh Gerak Makan Dan Putaran Spindel Terhadap Keausan Pahat Pada Proses Bubut Konvensional


Analysis of the Effect of Feeding Motion and Spindle Rotation on Tool Wear in Conventional Lathe Processes


  • (1) * Mohamad Miftakhul Rozaq            Universitas Muhammadiyah Sidoarjo  
            Indonesia

  • (2)  Iswanto Iswanto            Universitas Muhammadiyah Sidoarjo  
            Indonesia
    (*) Corresponding Author

DOI: https://doi.org/10.21070/r.e.m.v2i1.842

Abstract

This paper discuss the effect of feeding motion and spindle rotation and also the relationship between feeding motion and spindle rotation on wear of tool in conventional lathe process. In this study the machining parameters are feeding motion (f) that varied  at 0.12 mm/rev, 0.24 mm/rev and 0.35 mm/rev. With spindle rotation (n) that is 300 rpm, 650 rpm and 1000 rpm. While the cutting depth (a) is 0.5 mm. Then, the wearing edge of the tool was tested. The result of wear test in the edge of tool, show that (1) the greater the feeding motion the higher wear value of tool and the relationship is positively linear; (2) The  larger the spindle rotation the lower wear value of tool will be and the relationship is negatively  linear.

References

Didik Nurhadiyanto, “Analisis Pengaruh Kecepatan Pemakanan Dan Kedalaman Potong Terhadap Temperatur Pahat Pada Mesin Bubut” Staf Pengajar FT UNY. Vol. 7, No. 1, hal. 69 – 78, 2002.

Angger Bagus Prasetiyo, “Aplikasi Metode Taguchi Pada Optimasi Parameter Permesinan Terhadap Kekasaran Permukaan Dan Keausan Pahat HSS Pada Proses bubut Material ST 37” Jurusan Teknik Mesin, Universitas Nusantara PGRI Kediri.Vol. 13, No. 2, hal. 86 – 97, 2015.

Hendri Budiman dan Richard, “Analisis Umur Pahat Karbida Untuk Membubut Baja Paduan (ASSAB 760) Dengan Metoda Variable Speed Machining Test” Jurusan Teknik Mesin, Fakultas Teknologi Industri, Universitas Bung Hatta, Padang. Vol. 9, No. 1, hal. 31 – 39, 2007.

Mrihrenaningtyas dan Randi Prayadi, “Analisis Umur Pahat Dengan Variasi Sudut Geram, Kecepatan Dengan Dan Tanpa Pendingin” Jurusan Teknik Mesin, Institut Teknologi Adhi Tama Surabaya, hal. 233 – 246, 2015.

Picture in here are illustration from public domain image (License) or provided by the author, as part of their works
Published
2017-06-30
 
Issue
Vol 2 No 1 (2017): June
Section
Articles

Copyright (c) 2017 Mohamad Miftakhul Rozaq, Iswanto Iswanto

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Copyright Notice

Authors retain copyright and grant the journal right of first publication with the work simultaneously licensed under a Creative Commons Attribution 4.0 International License that allows others to share the work with an acknowledgement of the work's authorship and initial publication in this journal.